Adjusting
Your Rear Wheel Bearings![]()
see also Mark Hooper's Rear Wheel Bearing Replacement/Servicing write-up HERE
This is an adjunct to the "Painting Your Calipers" write-up. If you decide to paint your calipers, then you may as well check your wheel bearings while youre there! However, this procedure can be done any time you jack one of the rear wheels off the groundwhether it be to clean the area, to change or rotate a tire, or to do any brake work.
"So why do I want to check the bearings?," you are thinking. (See the diagram below) The bearing is the roller that is inside the wheel hub. The wheel actually rolls around the bearing. The bearing needs to be snug, but NOT too tight. A loose bearing will cause additional "play" within the hub. This means the wheels rotational axis can shift around a bit and this throws off the steering and handling geometry. This will also cause additional wear to the bearing. Conversely, a bearing that is too tight could potentially cause enough extra friction to limit the wheels rolling friction. This could lead to increased bearing temperatures and bearing failure.
Tools Required to check the bearings = a jack and your own hands.
Additional tools required to make the adjustment (IF NECESSARY) = wheel nut wrench (see the "Whats in your trunk [boot] section"J.K.), needle-nose pliers, flat screwdriver, and a Torque wrench (optional).
Check Procedure:
To do this, grab the tire with both hands, one on each side of it (top & bottom or forward & rear sides). If it is solid (without play) then you are done and your bearing is adjusted fine. If you can shake the wheel and feel play in the bearing, you should then proceed with "adjustment."
Adjustment Procedure:
Because you are tightening the bearing nut and then loosening it to a final position of only "finger tight", you can see why a torque wrench is not absolutely necessaryjust be careful! My bearings were fine, but Steve P. said he needed to adjust his. He said it made a noticeable difference in the play of the bearing and handling of the car.
Charlie has the following to add:
"It took me about 30 minutes to do both wheels. It does make a difference--the steering is tighter. I've been getting some excessive steering wheel vibration which I suspect is the brakes, perhaps a rotor, since I can feel it on the pedal and more when I brake; but there's definitely less of it at lower speeds. I guess the thing about problems like loose wheel bearings is that it takes a long time to happen, so you probably don't notice the gradual drop in performance of your car--but you'll notice it when you've taken up the slack!
"Drive the car around the block a few times after you've adjusted the bearings and check the wheels for heat. They ought to be slightly warm (that is if you live in California; God knows how long it takes for the back wheels to warm up in Ossett, Yorkshire!). If they are more than lukewarm, you've overtightened the nut, so loosen it up again. I drove about 20 minutes on the freeway at about 90mph and they were warmish; unlike the fronts, of course, upon which you could happily fry eggs. I'd take the temperatures with my two digital thermometers, but someone washed them in the sink, with the rest of the dishes--I'm not saying who for fear of reprisals."
Happy Elan-ing, Doug